Electronics Forum | Thu Aug 05 12:28:44 EDT 2004 | jasont
Hi YuKim, Have you considered purchasing 2nd hand machines? Tekmart International Inc. can help you find a cost effective solution for your additional SMT line requirements. We have in stock and access to several of the machines you've listed; -
Electronics Forum | Wed Jan 12 07:22:10 EST 2005 | cyber_wolf
We seem to have an accountability issue when it comes to operators building defective product. Currently we are putting a piece of masking tape with the assembly #, work order, and operator initials on our black trays at the end of the reflow oven. I
Electronics Forum | Thu Feb 10 16:45:36 EST 2005 | pjc
It all depends on what type of board you need to solder. If your boards are small in size and low thermal mass and your conveyor speed requirments are normal, then I'd say the OmniFlo 7 will do the job. It has a max zone temp setting of 280C. The cur
Electronics Forum | Wed Aug 31 03:35:41 EDT 2005 | Slaine
I have a through hole product that is currently built with HMP solder(93.5Pb,5Sn,Ag1.5). We then dip it in 60/40 SnPb to give a solderable finish as HMP tends to oxidise. We need the HMP as our Customers solder through reflow ovens. Some customers w
Electronics Forum | Wed Sep 07 04:28:26 EDT 2005 | Slaine
were looking at paste, wire, preforms and solder bars (for solder pots), concentraiting on HMP, sn62,96S, and 2 different sac alloys, we also have 7 different fluxes and 16 temination inks (which were also having to change for RoHS because the ink co
Electronics Forum | Sat Dec 17 11:45:40 EST 2005 | DAM
You know, many SMD components have copper alloy leads and then a copper (or Ni) barrier on them. On the copper (or Ni) barrier there is the finish. Usually the finish is made of Sn\Pb (tin-lead), and if I solder with a Sn\Pb solder paste it's all rig
Electronics Forum | Sun Jan 29 14:10:14 EST 2006 | gipos
Hi GS, We are contract manufacturer for small series of electronic equipment fully trained for SMT.Making mostly RF with only few QFPs,TSOPs...SMT machine assembly was made by local subcontractor when needed. Recently we acquired two Juki 730 machin
Electronics Forum | Mon Oct 23 12:58:28 EDT 2006 | grizzy
"Surface Mount Techniques has approximately 98 > percent of the world market share of large Panel > Stencil Printers". > > It sounds a little bit > strange to me, especially since I work for one of > the companys listed in their advertisement an
Electronics Forum | Fri Nov 17 16:24:18 EST 2006 | billwestiet
I'm in North Attleboro, small world. To answer your question, you can deposit small dots of paste with a syringe. Kind of tricky work, and there are small stencil soluions out there fairly inexpensively. See http://www.minimicrostencil.com/ (I do
Electronics Forum | Mon Jan 15 13:49:09 EST 2007 | leemeyer
Hello all, I am having some trouble with the conveyor speed on an Omniflow 7 reflow oven. Recent profiling showed that the conveyor was running to slow so I calibrated the speed using the instructions in the manual. After calibration there was no ch